Play Via Bluetooth - Taga Harmony HTR-1500CD Instruction Manual

Play via Bluetooth

Rotate the INPUT knob on the front panel or press the
select the BT input.
[BT MODE] and then [BT] will be displayed.
DEVICE NAME
The CD-Receiver Bluetooth
hex digits of its unique MAC address.
The CD-Receiver MAC address can be found in the Control Application: Settings →
Speaker Info.
PAIRING
1. As long as the same audio source device is being used with the CD-Receiver,
pairing needs only to be done once.
2. If no audio source device is paired with the CD-Receiver then then [BT] will blink.
- [BT] quickly blinking : the CD-Receiver is in the pairing mode.
- [BT] slowly blinking : press the PAIRING (►ll) button on the remote controller for 2
seconds or longer to enter the pairing mode. A voice prompt will be audible in
speakers or headphones.
3. Activate and select Bluetooth
etc.) and start scanning for available Bluetooth
4. After a short time "HTR-1500CD ####" will appear on the screen of your audio
source.
5. Select "Pair" on your audio source device to connect with the CD-Receiver.
After connection is successful [BT] stops blinking.
Note! For elder audio source devices, you may need to input "0000" as a pairing
password.
Note! Some audio source devices may not be compatible.
6. The CD-Receiver will now be ready to play your music wirelessly within a range of
approximately 5 meters. Start playback on your audio source device.
®
device name is "HTR-1500CD ####", where #### is 4 last
®
on your audio source device (smartphone, laptop
®
button on the remote controller to
devices.
®
32