Remote Controller - Taga Harmony HTR-1500CD Instruction Manual

Hybrid stereo cd-receiver
Table of Contents

Advertisement

Remote Controller

• Always use 2025 battery and do not use the rechargeable batteries.
• If the battery runs out, remove the old battery and replace it with a new one
• If the battery is placed incorrectly, it can cause explosion.
• Remove the battery if the remote controller is not used for a long period of time.
• Do not handle and store the batteries together with metallic tools.
• KEEP AWAY FROM CHILDREN!
Battery Installation
First use of remote controller
To activate the battery remove the protection which is located
on the bottom back side of the remote controller.
Replacement of the battery
Prepare a single 2025 battery.
1. Using a screwdriver, loosen the battery compartment screw, which is located on the back side
of the remote controller.
2. Pull out the battery compartment with your fingernails and remove the old battery.
3. Insert the new battery in the battery compartment keeping the same position like the original
battery to maintain the correct polarity.
4. Tighten the battery compartment screw.
1
Operating range
Use the remote controller by aiming it at the remote controller sensor.
The remote controller can operate in the maximum range
of 5 meters away from the CD-Receiver and within 30 degrees
from the axis of the controller sensor.
Note! Exposing the remote controller sensor
to direct sunlight or strong light may cause faulty operation.
9
within several minutes.
Remember that small button cell batteries such as used in this product may be
easily swallowed by young children and are dangerous for their health.
2
Remote Controller
3
Remote Controller Sensor
4

Advertisement

Table of Contents
loading

Table of Contents