Connecting The Transmitter; Connecting With The Usb Cable (Usb Input) - Panasonic SOUNDSLAYER SC-GNW10 Owner's Manual

Connecting the transmitter

Connecting with the USB cable (USB input)

Connect the transmitter to your game console's/PC's USB port. This device supports PC, PS4/PS5 Nintendo
Switch. This device does not support Xbox.
• Power is supplied from the USB port that the transmitter is connected to.
• Before connecting the transmitter, make sure your PC/Game Console is powered on.
• The operation indicator of the transmitter lights (cyan) when there is a wireless connection with the SC-GNW10 and
blinks (cyan) when there is no wireless connection with the SC-GNW10.
• If the operation indicator on the transmitter is blinking red, check that you have connected using the supplied USB
cable (approx. 1.0 m (3.2 ft)).
• In order to properly use the SC-GNW10, depending on the operating environment and OS, you need to change some
sound settings on the computer. (
A USB cable (supplied)
B PC, PS4/PS5 Nintendo Switch
C USB port
Note:
• Do not use any other USB cables except the one which is supplied. Doing so may cause a malfunction.
The shorter cable is specifically for recharging, and as such it cannot be used to connect with the transmitter.
• The operation indicator of the transmitter blinks (cyan) (no wireless connection with SC-GNW10), but the operation
indicator turns off after this continues for about a minute. The operation indicator turns off, but wireless connection is
possible when SC-GNW10 turns on. When connected wirelessly with SC-GNW10 or [-PAIRING] button operations
are performed, the indicator lights again.
Before use
l
10, "When connecting to a PC")


USB

9