ENACFIRE Forte - Wireless Earbuds Manual

Table of Contents

Contents

1 Packaging List
2 Product Overview
3 Power On & Pairing
- 3.1 Approach 1 - With Charging Case
- 3.2 Approach 2 - Without Charging Case
4 Incoming call
5 Music
6 Power Off
- 6.1 Mode 2 - Without Charging Case
7 Single Mode
8 Charging
- 8.1 Earphones
- 8.2 Charging Case
9 Safety Instruction
10 Customer Support
11 Documents / Resources
- 11.1 References
- 11.2 Download manual

Packaging List

Product Overview

Product Overview - Part 1

Charging Case LED Light
Charging Port
Multifunctional Button
Earphone LED
Magnetic Charging Pin
Earphone Mic

Power On & Pairing

Approach 1 - With Charging Case

Take out earphones from the charging case

Approach 1-With Charging Case
Select 'ENACFIRE Forte' from Bluetooth list

Approach 2 - Without Charging Case

Power On: Touch the earphones for 2 seconds Prompt sound 'Power on'
Pairing: Right earphone Blue and White light flash
Select 'ENACFIRE Forte'

Incoming call

Answer call/End call
Tap the Left/ Right earphone once

Reject call
Touch the Left / Right earphone for 2 seconds

Music

Pause/ Play
Tap the Left/ Right earphone once

Voice Assistant
Tap the Left/ Right earphone 3 times

Change Song
Double-tap the Left/Right earphone

Adjust Volume
Touch and hold the Left/Right earphone

Power Off

Mode 2 - Without Charging Case

Mode 2 - Without Charging Case
Turn off Bluetooth to disconnect the earphones
Touch either one earphone for 6 seconds to power off both earphones

Single Mode

Single Mode	Earphone
Without Charging Case	Turn off both earphones Touch the Left/Right earphone for seconds enter pairing mode, Select 'ENACFIRE Forte' from Bluetooth list

Charging

Earphones

Earphone LED Light on: Charging
Earphone Light Off: Fully Charged

warning Note: It takes about 1.5 hours to fully charge the earphones

Charging Case

Put the earphones back to the case. Lights on charging case stand for the remaining battery capacity.

Charging Case Red Light Flash 4 times. 75100% Charged
Charging Case Red Light Flash 3 times. 50-75% Charged
Charging case Red Light Flash 2 times. 25-50% Charged
Charging Case Red Light Plash 1 times: Charged

warning Note: It takes about 1.5-2 hours to fully charge the charging case

Safety Instruction

Using earphones at high to moderate volumes for extended periods of time will result in permanent hearing damage. It is advised that you keep volume levels moderate to low at all times for your safety. Do not use while driving, cycling, operating machinery or performing other activities that require hearing surrounding sounds.
Do not use earphones in thunderstorm weather, the earphones may not work properly in the bad weather condition, and may increase the risk of being hit by lightning.
Earphones may not work properly under high temperature or high humidity conditions.
Do not use any corrosive cleaner/oil to clean the earphones. If the earphones come in contact with liquids, quickly wipe away, If submersed in the water, do not turn the earphones on until it is completely dried.