ENACFIRE A9 - Wireless Earbuds Manual

Table of Contents

Contents

1 Packaging List
2 Product Overview
3 Power On & Pairing
- 3.1 Approach 1 -With Charging Case
- 3.2 Approach 2 -Without Charging Case
4 ANC/ Transparency Mode
5 Incoming call
6 Music
7 Power Off
8 Single Mode
9 Charging
- 9.1 Earphones
- 9.2 Charging Case
10 Safety Instruction
11 Customer Support
12 Documents / Resources
- 12.1 References
- 12.2 Download manual

Packaging List

Product Overview

Charging Case LED Light
Charging Port
Multifunctional Button
Earphone LED
Magnetic Charging Pin

Power On & Pairing

Approach 1 -With Charging Case

Open charging case cap

Approach 1 -With Charging Case
Select 'ENACFIRE A9" from Bluetooth list

Approach 2 -Without Charging Case

Power On: Touch the earphones far 2 seconds with prompt sound 'Power on'
Pairing: Right earphone Blue and White light flash Select 'ENACARE A9'

warning Note: Right earphone is the master earphone

ANC/ Transparency Mode

Tap Left earphone once to switch between ANC/Transparency mode
Active Noise Cancelation Mode
Prompt Sound: Noise cancelling on
Transparency Mode Prompt Sound: Ambient on

Incoming call

Answer call/End call
Tap the Left Right earphone once

Reject call
Touch the Left / Right earphone for 2 seconds

Music

Pause / Play
Tap the Right earphone once

Voice Assistant
Tap the Left/ Right earphone 3 times

Change Song
Double-tap the Left/Right earphone

Adjust Volume
Touch and hold the Left/Right earphone

Power Off

Without Charging Case

Turn off Bluetooth to disconnect the earphones Touch either one earphone for 8 seconds to power off both earphones

Single Mode

Single Mode	Earphone
Without Charging Case	Turn Off both earphones Touch the Left / Right earphone for 4 seconds enter pairing mode- Select 'ENACFIRE A9' from Bluetooth list

Charging

Earphones

Earphones white LEO Light blinking/off: Charging*Fully Charged

Charging Case

Charging Case white LED Light on/blinking: Fully Charged/Charging

warning Note: It takes about 1.5-2 hours to fully charge the charging case

Safety Instruction

Using earphones at high to moderate volumes for extended periods of time will result in permanent hearing damage. It is advised that you keep volume levels moderate to low at all times for your safety,
Do not use while driving, cycling, operating machinery or performing other activities that require hearing surrounding sounds.
Do not use earphones in thunderstorm weather, the earphones may not work properly in the bad weather condition, and may increase the risk of being hit by lightning.
Earphones may not work properly under high temperature or high humidity conditions.
Do not use any corrosive cleaner/oil to clean the earphones. If the earphones come in contact with liquids quickly wipe away. If submersed in the water, do not turn the earphones on until it is completely dried.

information Tips: Man-made damage and lost are not covered under warranty. Keep the earphones and the packaging out of reach of children.