Philips AWH1130 User Manual page 5

• The appliance is intended to be permanently connected to the water mains and not connected by
a hose-set.
• Before use, make sure that the electric water heater is installed correctly and completely. When
using it for the �rst time or after emptying it, the electric water heater must be �lled with water
before it is allowed to connect to the power supply. Do not use this product when there is no
water supplied to the electric water heater.
• The electric water heater must be properly and reliably grounded.
• Before installation or use, you must read and understand the instructions and safety warnings. If
you do not follow the instructions and safety warnings, it may cause serious injury or death.
• Make sure that the power supply matches the rated power and rated frequency. Make sure the
power plug is not damaged to prevent the risk of electric shock.
• In order to prevent the danger caused by the wrong reset of the temperature limiter, do not
connect this device through any external switching device (such as timer or circuit device
controlled by public facilities)
Ensure that the safety valve is always in working condition to prevent pressure accumulation,
prevent the back�ow of water entering the electric water heater and discharge excess pressure
when the inner pressure of the electric water heater is high, so as to ensure the life of the inner
tank and avoid the occurrence of bursting accidents. During the heating period, the pressure
relief port of the safety valve may drop water droplets. This is a normal phenomenon. Do not
block the pressure relief port due to this, so as to avoid serious safety accidents caused by the
failure of the electric water heater to relieve pressure.
• If the water pressure of the tap water used by the user is too high, the pressure relief port of the
safety valve may frequently release the pressure and discharge water. At this time, a pressure
reducing valve should be installed on the water inlet pipe, and the pressure reducing valve
should be installed in a place away from the water heater.
• Too high water temperature can cause serious burns and scalds.
• Before repairing or checking the electric water heater, make sure the power is cut off.
• The instruction manual must be placed next to or near the device for future reference.
02