Usage Method - Philips AWH1130 User Manual

7. Usage Method

Preparation before use
• Water injection: Open the water mixing valve, lift the handle of the mixing valve, turn it clockwise
to the highest point in the high temperature area, and then open the water inlet valve. At this
time, water will be injected into the inner tank until the hot water outlet is normal. At this time
Indicates that the inner tank has been �lled with water, close the water mixing valve, and turn the
handle counterclockwise to the lowest point in the low temperature zone.
Close
• When the water temperature reaches the set temperature, the heating indicator on the panel will
turn green, and the water heater will automatically stop heating. The water temperature has
reached the set temperature and enters the heat preservation state. At this time, the user can
turn on the switch of the mixing valve and slowly turn from the low temperature zone to the heat
preservation state. Rotate the handle of the mixing valve in the high temperature area, carefully
test the water temperature with your hands, adjust it to the water temperature you need, and
then you can use it with con�dence. When the water temperature drops to a certain temperature,
the water heater will automatically reheat.
Note: the water temperature may be slightly higher, please test the water temperature before
use, do not test the water temperature on the human body, so as to avoid burns!
Function description
Open Low temperature
Power indicator light: Indicator lights up when power on .
Heating indicator light: Indicator lights up when heating.
Knob: Temperature adjustment knob
09
High temperature