Philips AWH1130 User Manual page 10

Note: When installing the safety valve, be sure to recognize the water �ow direction sign on the
safety valve and install it correctly, and tighten the upper and lower installation nuts to avoid water
leakage. After installation, lift the handle (Figure 5), check whether the safety valve is normal, and
then reset.
Pipe connection:
• Electric water heaters should be installed on the correct size pipes and �ttings and should be
clean
• The speci�cation of the water inlet pipe of this product is G1/2", and the threaded port needs to
be sealed with a sealing waterproof tape or a sealing ring.
• In order to facilitate the installation and disassembly of the water heater, it is recommended to
Hot water
Relief hose
of safety valve
Figure 4
Figure 5
Plug
Water heater
Into cold water
Water
mixing valve
Handle
Drain horse
07
Cold water valve
Shower head