Table of Contents
Advertisement
Hardware Specifications
Ceiling/Wall Mounting
To mount an AP100 or AP200 device to a ceiling or wall:
1. Position the mounting bracket on the wall or ceiling where you want to install the WatchGuard AP
device.
2. Use the mounting bracket as a guide to mark the position of the WatchGuard AP device on the wall or
ceiling.
3. Remove the mounting bracket and insert the large mounting screws into the marks you made on the
ceiling or wall.
4. Insert the long 5x32 screws through the bracket and into the mounting screws.
5. Insert the short 6x12 screws partway into the bottom of the device. Do not tighten the screws
completely. Keep the heads of the screws exposed to attach the device to the mounting bracket.
6. If extra space is required between the device and the mounting bracket, use the spacers and long 6x25
screws from the T-rail mounting hardware kit.
7. To attach the device to the mounting bracket, insert the screw heads from the device into the slots in
the mounting bracket, and rotate the device clockwise to lock the device in place.
8
WatchGuard AP100 and AP200
Advertisement
Table of Contents
