Watchguard AP100 Hardware Manual page 8

Hardware Specifications
Connect the Ethernet Power Injector
To connect an Ethernet Power Injector to the WatchGuard AP device:
1. Attach a region-specific plug to the Ethernet Power Injector.
2. Plug the Ethernet Power Injector into an AC power source.
3. Connect a straight-through Ethernet cable from your network backbone (for example, a router, switch,
or hub) to the IN connector on the Ethernet Power Injector.
4. Connect a straight-through Ethernet cable from the WatchGuard AP device Ethernet interface to the
OUT connector on the Ethernet Power Injector.
Ethernet Power Injector Specifications
WatchGuard Part #
Specification
AC Input Voltage Rating
Output Voltage
Output Power
PoE Power Class
Ethernet Interfaces
Region-specific
Adapter Plugs
Indicator
Temperature
Humidity
Dimensions
Weight
6
Ethernet Power Injector
WG8568
IEEE 802.3af/at
100 to 240VAC
56V
15.4W
3
In: RJ-45 for 10/100 Mbps
Out: RJ-45 for 10/100 Mbps and 56V DC
Voltage on pins 4-5 (+) and 7-8 (-).
US, EU, UK, AU
Green — Valid PoE load detected and connected.
Flashing Green/Red — Invalid load connected.
Red — Fault detected.
Operating 0 to +40°C
Storage -25 to +65°C
Operation 5 to 90%
L = 80mm (3.15in)
W = 45mm (1.77in)
H = 33mm (1.29in)
95g (3.35oz.)
WatchGuard AP100 and AP200