Interval Recording Mode - Canon C200B Instruction Manual

Interval Recording Mode

Set the interval in advance. At each interval, the camera will record one frame. Sound is not recorded in this
mode.
Operating modes:
Activating and Configuring
1 Open the [Recording Mode] submenu.
> [Æ ! Recording/Media Setup] > [Recording Mode]
2 Select [Interval Recording] and then press the joystick.
• [INT STBY] appears at the top of the screen (with [INT] flashing).
3 Open the [Recording Interval] submenu.
> [Æ ! Recording/Media Setup] > [Recording Interval]
4 Select the desired interval and then press the joystick.
• You can select one of 7 interval settings from 1 second to 10 minutes.
Recording
1 Press the REC button to begin recording.
• The camera automatically records one frame at the specified interval.
• The tally lamp illuminates.
• [INT STBY] changes to [Ü INT REC] while recording frames, and [Ü INT] and a countdown until the next
recording between recordings.
2 Press the REC button again to stop recording.
• All of the recorded frames are joined together into one clip.
• The tally lamp goes out and [INT STBY] appears at the top of the screen (with [INT] flashing).
3 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 of the previous procedure selecting [Normal Recording] instead.
NOTES NOTES
• You can use only one special recording mode at a time.
• The interval cannot be changed while recording.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• If you change the main recording format or system frequency, interval recording mode will be canceled.
• About the time code during interval recording mode:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.
- If the time code running mode was set to [Free Run], the time code running mode will be changed
automatically to [Rec Run] when interval recording is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the SDI terminal or HDMI OUT terminal.
Special Recording Modes
117