Water Connection - Hyundai DFA 1267 DX7 Instruction Manual

gROUNDINg INSTRUCTION
This appliance must be grounded. In the event of a malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance of electric current. This
appliance is equipped with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriateoutlet that is installed and grounded in accor-
dance with all local codes and ordinances.
wARNINg!
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the appli-
ance is properly grounded. Do not modify the plug provided with the appliance; If it is not fit for
the outlet. Have a proper outlet installed by a qualified electrician.
wARNINg!
In order to avoid that there is more water staying in the inlet hose, please close the hydrant after
using.(For the models: no safety inlet hose.)
Cold water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water
run to make sure t hat the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.
hot water Connection
The water supply to the appliance can also be connected to the house hot water line (centrali-
zed system, heating system),as long as it does not exceed a temperature of 60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency
slightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water
supply and drain hoses that can be positioned to the right or the left to facilitate proper installati-
on.
Levelling the Appliance
Dishwasher must be level for proper dish rack operation and wash performance.
1) Place level on door and rack track inside the 1 tub as shown to check that the dishwasher is
level.
EN - 80