A) Water Softener; B) Loading The Salt Into The Softener - Hyundai DFA 1267 DX7 Instruction Manual

NOTE: If your model have not water softener, you may skip this selection.
wATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher,
deposits will from on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to elimi-
nate lime and minerals from the water.
b. Loading the Salt into the Softener
Always use salt intende d for use with dis hwasher.
The salt container is located beneath the lower rack and should be filled as follows:
Attention!
Only uses alt specifically designed for use in dishwa shers! All other types of salt not specifically
designed for use in a dishwas her, especially tablesalt, will damage the water softener. In case
of damage s ca used by the use of unsui tabl e salt the manuf acturer does not give any warran-
ty or is liable for any cause damages.
Only fill withs alt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split, remai ni ng of the
bottom of the machine for any period of time, which may cause corrosion.
After the first wash cycle the control panel light expires .
a) Remove the lower basket and then unscrew and remove the cap from the salt container.
b) If you are filling the container for the first time, fill 2/3 of its volume with water (around
500ml).
c) Place the end of the funnel (supplied) into the hole and introduce about 1,2kg of salt. It is
d) Normal for a small amount of water to come out of the salt container.
e) Carefully screw the cap back on.
f) Usually, the salt warning light will be off in 2-6 days after the salt container be filled with salt.
NOTE:
1) The salt container must be refilled when the salt warning light in 1. the control panel comes
on. Though the salt container is filled enough, the indicator light may not black out before
the salt fully dissolve. If there is no salt warning light in the control panel (for some models) ,
you can judge when to load the salt into the softener by the cycles that the dishwasher had
run (see the foregoing schema ).
) If there are spills of the salt, a soak program could be run to wipe them out.
EN - 65
EN