Water Connection - Hyundai DTB 656 DW7 Instruction Manual

Note: danger voltage in the appliance.
gROUNDINg INSTRUCTION
This appliance must be grounded. In the event of a malfunction or breakdown, grounding
will reduce the risk of electric shock by providing a path of least resistance of electric current.
This appliance is equipped with a cord having an equipment-grounding conductor
and a grounding plug. The plug must be plugged into an appropriateoutlet that is installed
and grounded in accordance with all local codes and ordinances.
wARNINg!
Improper connection of the equipment-grounding conductor can result in a risk of electric
shock. Check with a qualified electrician or service representative if you are in doubt whether
the appliance is properly grounded. Do not modify the plug provided with the appliance;
If it is not fit for the outlet. Have a proper outlet installed by a qualified electrician.
wARNINg!
In order to avoid that there is more water staying in the inlet hose, please close the hydrant
after using.(For the models: no safety inlet hose.)
Cold water Connection
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is
fastened tightly in place. If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure t hat the water is clear and free of impurities.
If this precaution is not taken, there is a risk that the water inlet can get blocked and damage
the appliance.
hot water Connection
The water supply to the appliance can also be connected to the house hot water line
(centralized system, heating system),as long as it does not exceed a temperature of 60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency
slightly reduced. The connection must be made to the hot water line following the same
procedures as those for the connection to the cold water line.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water
supply and drain hoses that can be positioned to the right or the left to facilitate proper
installation.
Levelling the Appliance
Dishwasher must be level for proper dish rack operation and wash performance.
1) Place level on door and rack track inside the 1 tub as shown to check that the dishwasher
is level.
) When level the dishwasher, please pay attention not to let the dishwasher tip over.
EN - 68