Table of Contents
Advertisement
MANAGER
Two Manager Passwords are available as an added meas ure; one password accesses the PRG (PROGRAM), and
one accesses the "X" and "Z" modes. The Manager Password
password has been programmed, it must be entered every time you access the program mode or before every "X"
or "Z" reading is taken.
NOTE: If the Manager Password is programmed as (0000), the machine will not acknowledge this password.
CAUTION: Please w rite y our passw ords dow n in a safe place. If the passw
SYSTEM CLEAR procedure w ill be necessary . A Full Sy stem Clear w ill erase all transaction
programming. For details on the Full System Clear see Page 94.
TO SET THE PROGRAM MODE MANAGER PASSWORD
"PRG" + (19) + [QTY/TIME] + (PASSWORD #) + [AMT TEND/TOTAL]
Example: If the Manager Password is 1212:
1.
Turn the key to the "PRG" (PROGRAM) position.
TYPE (19), PRESS [QTY/TIME], TYPE (1212), then PRESS the [AMT TEND/TOTAL] key.
2.
TO USE THE PROGRAM MODE MANAGER PASSWORD
Turn the key to the "PRG" (Program) position.
1.
2.
Input the password and PRESS the [CLERK] key.
3.
You are now ready to program.
TO PROGRAM THE X and Z MODE MANAGER PASSWORDS
"PRG" + (18) + [QTY/TIME] + (MANAGER PASSWORD #) + [AMT TEND/TOTAL]
Example: If the X and Z mode password is 1313:
1.
Turn the key to the "PRG" (PROGRAM) position.
2.
TYPE (18), PRESS [QTY/TIME], TYPE (1313), then PRESS [AMT TEND/TOTAL].
TO USE THE "X" and "Z" MANAGER PASSWORD
Example: Access the X or Z modes, when the Manager Password is 1313:
1.
Turn the key to the "X" or "Z" mode as needed.
2. TYPE
(1313), then PRESS the [CLERK] key.
3.
You are now ready to take any reports based on your selection in Step 1.
1 - 4 digit #
"PRG" + (PASSWORD #) + [CLERK]
1 - 4 digit #
1 - 4 digit #
"X" or "Z" + (MANAGER PASSWORD #) + [CLERK]
1 - 4 digit #
resets every time it is used, therefore once a
ords are forgotten, a FULL
PASSWORDS
data and
20
Advertisement
Table of Contents
