Craftsman Sun Shade 486.24226 Owner's Manual page 6

• Fasten top tubes to upright tubes using two 1/4" x
1-1/4" hex bolts (A) and two 1/4" nylock nuts (D). See
figure 8.
• Insert one end of the remaining support rod into
the small hole in one of the upright tubes. Insert the
other end of the support rod into the small hole in the
other upright tube. It will be necessary to flex the rod
slightly so it can be inserted in the second hole. See
figure 8.
SUPPORT ROD
1/4" x 1-1/4"
HEx BOLT (A)
FIGURE 8
1/4" NYLOCK NUT (D)
• Insert the small loop of the spring hook through the
hole at one end of the tarp strap. See figure 9.
• Insert an S-hook through the other end of the tarp
strap. See figure 9.
• Hook the spring hook over the end of the cross tube
and attach the S-hook to the bottom edge of the
tractor fender. See figure 9.
• Repeat above steps for other tarp strap. Attach to
opposite end of cross tube. See figure 9.
TRACTOR FENDER
FIGURE 9
6
CROSS
TUBE
SPRING
HOOK
TARP STRAP
S-HOOK