Panasonic CZ-CFUSCC1 Installation Instructions Manual page 7

Cloud adaptor
Hide thumbs Also See for CZ-CFUSCC1:
Table of Contents

Advertisement

Remove the check mark from [DHCP Enabled], and
12
enter the IP address, subnet mask and default gateway
specifi ed on the network to be install.
Remove the check mark from [Obtain DNS server
13
address automatically], and enter the IP addresses of
the DNS server 1 and DNS server 2.
 To cancel
Press
.
14
Press
.
• Press [Yes] on the confi rmation screen to save the setting items.
Press [No] to cancel the settings and return to the network setting
screen.
15
Press
.
(The setting mode selection menu is displayed.)
Turn the power off .
16
Power Switch
Using the DIP switch, set the mode of the cloud adaptor
17
to the operation mode.
Do not change the setting
of switch 1 from the ON
position.
Change the setting of
switch 2 to OFF position.
Remove the LAN cable from the cloud adaptor, and
18
connect the other to the network.
12
13
15
14
Off
LED
18
OFF
Operation mode
17
ON
OFF
1 2 3 4
LAN Cable
PC
network
Turn the power on.
19
• Confi rm the Green LED (LED 18) lights up and after a while, the
Orange LED (LED 17) blinks at high speed.
ON
Lighting
(Green)
Power Switch
20
Start up the unit in simple setting mode.
• While the Orange LED (LED 17) is blinking at high speed, the unit
is in simple setting mode selection standby. Press and hold the
SW6 switch for at least 1 second within 10 seconds. When the
LED changes to the simple setting mode, release the switch.
Simple setting mode:
The Orange LED (LED 17) lights up and the Green LED
(LED 16) and Red LED (LED 15) blink at low speed.
• If the SW6 switch is not pressed within 10 seconds, the simple
setting is not performed and the unit starts up in operation mode.
In this case, perform the procedure from step 16 again.
LED
LED
LED
17
16
15
• If the simple setting fails halfway, an error status is displayed on
LEDs and the setting is canceled.
• Refer to "Self-diagnostics table and detected contents" (P.14) and
check the error status.
• When the simple setting has fi nished normally, the unit
automatically restarts in operation mode and is connected to the
cloud server.
Blinking
(Orange)
Off
Off
LED
LED
LED
17
16
ON
Simple setting mode
Simple setting
selection standby
mode
Blinking
Lighting
(Orange)
Off
(Orange)
Off
Blinking
(Green)
15
Blinking
(Red)
7

Advertisement

Table of Contents
loading

Table of Contents