Table of Contents
Advertisement
Quick Links
10 Aug 2022
TABLE OF CONTENTS:
1.00
BEAMS & CONNECTORS:
1.10
1.11
1.12
1.20
1.30
1.31
1.32
2.00
2.10
2.20
2.30
3.00
3.10
3.20
3.30
3.31
3.40
3.41
3.42
3.43
Revision History:
Date
email:
info@matsing.com
MS-24C90
Date
Prepared by
Ray Ling
INSTRUCTION MANUAL MS-24C90
Beam 13-24
Beam 1-12
Description
website:
Instruction Manual
Approved by
Pavel
www.matsing.com
Document nos
MS-24C90-IM-001
Revised by
Rev nos
Page
Revision
0
1
/
7
Advertisement
Table of Contents
Related Manuals for Matsing MS-24C90
Summary of Contents for Matsing MS-24C90
- Page 1 Date Prepared by Approved by Document nos Revision 10 Aug 2022 Ray Ling Pavel MS-24C90-IM-001 INSTRUCTION MANUAL MS-24C90 TABLE OF CONTENTS: 1.00 BEAMS & CONNECTORS: 1.10 Plan View Resultant Beam Direction 1.11 Beam 1-12 (Top Row 1) 1.12 Beam 13-24 (Second Row 2) 1.20...
- Page 2 1.00 BEAMS & CONNECTORS: 1.10 Plan View Resultant Beam Direction 1.11 Beam 1-12 (Top Row 1) 0˚ BEAM 1 - 12 (Top Row 1) Plan View Resultant Beam Directions Frequency: 3700 – 00 MHz 1.12 Beam 13-24 (Second Row 2) 0˚...
- Page 3 1.20 Rear View Connector Layout MS-24C90 REAR VIEW CONNECTOR LAYOUT 1.30 Connector Port Table (From Rear View) 1.31 Beam 13-24 BEAM BEAM BEAM BEAM BEAM BEAM BEAM BEAM BEAM BEAM BEAM BEAM PORT PORT PORT PORT PORT PORT PORT PORT...
- Page 4 2.00 BEAM PATTERN 2.10 Vertical Beam Pattern 2.20 Horizontal Beam Pattern (Row 1) 2.30 Horizontal Beam Pattern (Row 2) Page...
- Page 5 3.00 TRANSPORTATION / INSTALLATION 3.10 Transportation (From Point to Point) Strictly comply to the Local authority and regulatory on Workplace Safety and Health Control and Measure when moving and transportation of large or heavy equipment, appropriate material handling machine should be use. (Risk Assessment apply for Forklift or Pallet Truck Lifting) 3.20 Bracket Mounting...
- Page 6 3.30 Installation using a crane Strictly comply to the local authority and regulatory on Workplace Safety and Health Control and Measure when performing lifting of large or heavy equipment, appropriate material handling machine should be used and only certified personnel should perform the task. (Risk Assessment requirement applies for both Up-Lifting and Down-Lifting.) 3.31 Lifting the Antenna...
- Page 7 3.40 Antenna Installation With reference to "Bracket Mounting Procedure", End user is required to Custom-Make the additional supporting bracket and tighten it to the existing Antenna bracket to meet the deployment needs. 3.41 Antenna Leveling After the Antenna is mounted to the bracket, it is required to be adjusted to 0˚ (Zero Degree) with ≤0.2˚...
Need help?
Do you have a question about the MS-24C90 and is the answer not in the manual?
Questions and answers