Table of Contents
Advertisement
Trouble shooting
en
The temperature sensor indi-
cator is not lighting up
The indicator on the tempera-
ture sensor flashes twice.
The indicator on the tempera-
ture sensor flashes three
times.
"Š‹‹‹
"Š‹‚‹
—...‹‹
š"
Do not place hot pans on the control panel.
--------
Notes
If
appears on the display, press and hold the
"
■
button for the relevant cooking zone in order to read
the fault code.
If the fault code is not listed in the table, disconnect
■
the hob from the mains power supply and wait
30 seconds before reconnecting it. If this code is
displayed again, contact the technical after-sales
service and specify which fault code has appeared.
If a fault occurs, the appliance will not switch to
■
standby mode.
46
The temperature sensor is not responding and
the indicator is not lighting up.
The battery in the temperature sensor has almost
run out. You may be interrupted the next time you
cook by the battery running out.
The temperature sensor is disconnected.
The operating voltage is incorrect/outside of the
normal operating range.
The hob is not connected properly
Demo mode is activated
Replace the 3 V CR2032 battery. See the section entitled
~ "Changing the battery"
If this does not solve the problem, press and hold the symbol on
the temperature sensor for 8 seconds and then reconnect the
temperature sensor to the hob.
If the problem persists, contact the technical after-sales service.
Replace the 3 V CR2032 battery. See the section entitled
~ "Changing the battery"
Press and hold the symbol on the temperature sensor for 8 sec-
onds and then reconnect the temperature sensor to the hob.
Contact your energy supplier.
Disconnect the hob from the power supply. Check that it has been
connected as shown in the circuit diagram.
Disconnect the hob from the power supply. Wait for 30 seconds
before reconnecting it. Touch any touch control in the next
3 minutes to deactivate demo mode.
Advertisement
Table of Contents
