Reset The Cable Modem Configuration Settings; Reboot The Cable Modem; Exit The Web Manager - Arris SURFboard SB8200 DOCSIS User Manual

Chapter 5: Monitoring your cable modem and protecting your connected network
2. To enable Link Aggregation Configuration, click Enable LAG checkbox.
3. Click Apply/Save.

Reset the cable modem configuration settings

You can restore the factory default configuration settings on your SB8200. This process will
delete the current SB8200 configuration settings and take approximately five to 30 minutes
to complete. Your network connection will remain disabled until after the SB8200
configuration settings are restored.
Warning: This process will delete the current SB8200 configuration and replace it
with the factory default settings.
To restore the factory default settings on your SB8200:
1. Insert the end of a paper clip or other small object with a narrow tip into the Reset
opening on the back of your SB8200.
2. Press and hold the Reset button for 10 seconds or until the front panel LEDs flash.
3. Remove the paper clip or small object from the opening Reset.

Reboot the cable modem

To restart your SB8200:
1. Insert the end of a paper clip or other small object with a narrow tip into the Reset
opening on the back of your SB8200.
2. Press and hold the indented Reset button for three to four seconds only, and then
release.
Warning: If you press the Reset button for more than seven seconds, the cable
modem configuration settings will be reset to the factory default settings.

Exit the Web Manager

To exit the Web Manager:
■ Click Logout in the upper right corner of the web browser window.
SURFboard ® SB8200 DOCSIS ® 3.1 Cable Modem User Guide DRAFT Revision x.5 24