Step 4: Erect and secure the post.
1. Make the posts face to each other and the distance between the posts equals to the length of the crossbeam. Use proper means to erect
the post.
2. Use suitable means to raise the lifting carriage to the first latching position. All the mounting holes in the base plate are then accessible.
Make sure the locking pawl is engaged.
3. Check and align the position of the base plates again.
4. Drill the mounting holes. Remove the drilling dust from the hole.
5. Use a spirit level to check the vertical alignment of the posts. If necessary, place equalizing plates under the base plates.
6. Tighten the nuts. Torque: (63‐74b.ft) 80‐100Nm
Anchoring bolt
(foundation thickness )
Installation, Operation and Parts Manual
A1
A2
(drilling depth)
A.
Nut
B.
Expansion anchoring bolt
C.
Equalizing plate
A3
(anchoring depth)
15
MJ-C10
B
C