General Installation Steps - Major MJ-C10 Installation Manual

4.2.3 Do not place any vehicle on the lift in the case of trial running.
4.3 General installation steps
ONLY TRAINED AND QUALIFIED INSTALLERS CAN PERFORM LIFT INSTALLATION DUTIES.
Step 1: Remove the packaging and take out the accessories attached.
：
Attention The packs must be opened adopting all the precautions required to avoid injury to persons (keep at a safe distance when cutting
the straps) or damage to parts of the machine (be careful that no parts are dropped while you are opening the packing).
Use proper means (put something supporting under the post or suspend the post by a crane) to suspend the post, unscrew and remove
the bolts fixed on the iron rack.
：
Attention Please pay special attention not to let the post fall down for it may cause casualty or bring damages to the accessories fixed in the
post.
Step 2: Fix the standing position for the two posts. (See Annex 1, floor plan)
1. Decide on which post the power unit is going to be mounted.
2. Draw an outline of the base plate on the installation ground with chalk and ascertain the position for the two posts.
Step 3: Assemble the two posts.
1. Hex nut M14
2. Flat washer M 14
3. Spring washer M14
4. Hex head full swivel screw M14*30
5. Extending post
Installation, Operation and Parts Manual
1. Hex bolt
2. Iron rack
14
MJ-C10