AIMS Power PWRINV800W Instruction Manual

AIMS Power PWRINV800W Instruction Manual

Dc to ac power inverter

Advertisement

Quick Links

DC TO AC POWER INVERTER
PWRINV800W
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PWRINV800W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AIMS Power PWRINV800W

  • Page 1 DC TO AC POWER INVERTER PWRINV800W INSTRUCTION MANUAL...
  • Page 2: Basic Operation

    • When unpacking, make sure that the inverter is in good condition. If any parts are missing or broken, please call AIMS Power, Inc. at the number found on the warranty card. • Place the power inverter on a flat surface. Make sure it has adequate ventilation and is not in direct sunlight.
  • Page 3 operation of the inverter. It also reduces the fear of being stranded with a dead battery (dependent on health of battery). • This device should only be serviced by a qualified technician. This item does not have any serviceable parts. •...
  • Page 4: Battery Use

    Battery Use • To avoid over-discharging your vehicle battery, we recommend running your engine for 10-20 minutes to recharge the vehicle's battery if battery voltage drops <11V. • To properly size your battery, use the following formula: Volts * Amps = Watts or Watts/Volts = Amps.
  • Page 5: Measuring The Ac Voltage

    Make sure the inverter is turned off before installing the remote switch. Plug the switch into the remote jack and then turn the main switch to the OFF position for the remote to work properly. Measuring The AC Voltage The output waveform of the inverter is a MODIFIED SINE WAVE. If you choose to measure the AC output voltage, you must use a TRUE RMS MULTI METER.
  • Page 6: Troubleshooting

    TROUBLESHOOTING If the Inverter does not appear to be functioning properly, check the following possible causes: • Poor contact: Clean contact parts thoroughly. • If the low battery alarm sounds, this means the input voltage is too low and battery needs to be recharged.
  • Page 7: Specifications

    SPECIFICATIONS MODEL NO PWRINV800W DC Input Voltage 12V (10-15V) Output Wave Form Modified Sine Wave Output Power 800W Surge Power Capacity 1600W for 40 milsec Efficiency Over 90% No Load Current 0.6 A DC 10.5 + _ 0.5 V Battery Low Alarm DC 9.5 + _ 0.5 V...
  • Page 8: Warranty

    In no event shall AIMS be liable for indirect, special or consequential damages. This warranty only applies to AIMS Power branded products. All other name brand products are warranted by and according to their respective manufacturer. Please do not attempt to return non-AIMS Power branded products to AIMS Power.

Table of Contents