AIMS Power PWRINV400W Instruction Manual

AIMS Power PWRINV400W Instruction Manual

Dc to ac power inverter

Advertisement

Quick Links

DC TO AC POWER INVERTER
PWRINV400W
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PWRINV400W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AIMS Power PWRINV400W

  • Page 1 DC TO AC POWER INVERTER PWRINV400W INSTRUCTION MANUAL...
  • Page 2: Basic Operation

    • When unpacking, make sure that the inverter is in good condition. If any parts are missing or broken, please call AIMS Power, Inc. at the number found on the warranty card. • Place the power inverter on a flat surface. Make sure it has adequate ventilation and is not in direct sunlight.
  • Page 3 operation of the inverter. It also reduces the fear of being stranded with a dead battery (dependent on health of battery). • This device should only be serviced by a qualified technician. This item does not have any serviceable parts. •...
  • Page 4: Battery Use

    Battery Use • To avoid over-discharging your vehicle battery, we recommend running your engine for 10-20 minutes to recharge the vehicle's battery if battery voltage drops <11V. • To properly size your battery, use the following formula: Volts * Amps = Watts or Watts/Volts = Amps.
  • Page 5: Measuring The Ac Voltage

    option to turn the inverter on/off if the inverter is installed in a hard to reach area. Make sure the inverter is turned off before installing the remote switch. Plug the switch into the remote jack and then turn the main switch to the OFF position for the remote to work properly.
  • Page 6: Troubleshooting

    • If there is anything wrong with the inverter, disconnect all of the power and contact technical support. TROUBLESHOOTING If the Inverter does not appear to be functioning properly, check the following possible causes: • Poor contact: Clean contact parts thoroughly. •...
  • Page 7: Specifications

    The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto. SPECIFICATIONS MODEL PWRINV400W DC Input Voltage 12V (10-15V) Output Wave Form Modified Sine Wave...
  • Page 8: Warranty

    In no event shall AIMS be liable for indirect, special or consequential damages. This warranty only applies to AIMS Power branded products. All other name brand products are warranted by and according to their respective manufacturer. Please do not attempt to return non-AIMS Power branded products to AIMS Power.

Table of Contents