AIMS Power PWRINV150W Instruction Manual

AIMS Power PWRINV150W Instruction Manual

Dc to ac power inverter

Advertisement

Quick Links

DC TO AC POWER INVERTER
PWRINV150W
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PWRINV150W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AIMS Power PWRINV150W

  • Page 1 DC TO AC POWER INVERTER PWRINV150W INSTRUCTION MANUAL...
  • Page 2: Basic Operation

    • When unpacking, make sure that the inverter is in good condition. If any parts are missing or broken, please call AIMS Power, Inc. at the number found on the warranty card. • Place the power inverter on a flat surface. Make sure it has adequate ventilation and is not in direct sunlight.
  • Page 3 operation of the inverter. It also reduces the fear of being stranded with a dead battery (dependent on health of battery). • This device should only be serviced by a qualified technician. This item does not have any serviceable parts. •...
  • Page 4: Battery Use

    Battery Use • To avoid over-discharging your vehicle battery, we recommend running your engine for 10-20 minutes to recharge the vehicle's battery if battery voltage drops <11V. • To properly size your battery, use the following formula: Volts * Amps = Watts or Watts/Volts = Amps.
  • Page 5: Safety Precautions

    measure the AC output voltage, you must use a TRUE RMS MULTI METER. Using any other type of voltage measuring device will result in an AC voltage reading of 10 to 30 volts lower than actual voltage. When using a true RMS multi meter, you will get an accurate reading.
  • Page 6: Maintenance

    • If the low battery alarm sounds, this means the input voltage is too low and battery needs to be recharged. • If you are getting a low output voltage, try reducing the load to minimize watts. You may have overloaded the inverter.
  • Page 7: Specifications

    SPECIFICATIONS MODEL NO : PWRINV150W DC Input Voltage 12V (10-15V) Modified Sinewave Output Wave Form Output Power 150W Surge Power Capacity 300W for 40 milsec Efficiency Over 90% No Load Current 0.4A DC 10.5 + _ 0.5V Battery Low Alarm DC 9.5 + _ 0.5V...
  • Page 8: Warranty

    In no event shall AIMS be liable for indirect, special or consequential damages. This warranty only applies to AIMS Power branded products. All other name brand products are warranted by and according to their respective manufacturer. Please do not attempt to return non-AIMS Power branded products to AIMS Power.

Table of Contents