Security - Packard Bell EasyNote LJ75 Service Manual

Security

The Security screen contains parameters that help safeguard and protect your computer from unauthorized
use.
Information Main
Supervisor Password Is: Supervisor Password Is:
User Password Is: User Password Is:
SATA Port0 Disk Status: SATA Port0 Disk Status:
Set Supervisor Password Set Supervisor Password
Set User Password Set User Password
Set SATA Port0 HDD Password Set SATA Port0 HDD Password
Password on Boot Password on Boot
F1 Help
ESC Exit
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
Supervisor Password Is
User Password Is
SATA Port0 Disk Status
Set Supervisor Password
Set User Password
Set SATA Port0 HDD
Password
Password on Boot
NOTE: When you are prompted to enter a password, you have three tries before the system halts. Don't forget
your password. If you forget your password, you may have to return your notebook computer to your
dealer to reset it.
32
All manuals and user guides at all-guides.com
InsydeH20 Setup Utility
Advanced Security Power
Clear Clear
Clear Clear
Froze Froze
[Disabled] [Disabled]
Select Item Change Values
F5/F6
Select Menu Enter Select
Description
Shows the setting of the Supervisor password
Shows the setting of the user password.
Shows the status of the SATA Port0 disk.
Press Enter to set the supervisor password. When set,
this password protects the BIOS Setup Utility from
unauthorized access. The user can not either enter the
Setup menu nor change the value of parameters.
Press Enter to set the user password. When user
password is set, this password protects the BIOS Setup
Utility from unauthorized access. The user can enter
Setup menu only and does not have right to change the
value of parameters.
Enter HDD Password.
Defines whether a password is required or not while the
events defined in this group happened. The following
sub-options are all requires the Supervisor password
for changes and should be grayed out if the user
password was used to enter setup.
Boot Exit
Item Specific Help
Install or Change the
password and the length
of password must be less
than eight words.
F9 Setup Default
SubMenu F10 Save and Exit
Rev. 3.5
Option
Clear or Set
Clear or Set
Froze or ?
N/A
N/A
N/A
Disabled or
Enabled
Chapter 2