Table of Contents
Advertisement
4.
Use an electric conductivity tool to short the two points of the HW Gap.
5.
Plug in AC, keep the short condition on the HW Gap, and press Power Button to power on the system till
BIOS POST finish. Then remove the tool from the HW Gap.
6.
Restart system. Press F2 key to enter BIOS Setup menu.
7.
If there is no Password request, BIOS Password is cleared. Otherwise, please follow the steps and try
again.
NOTE: These steps are only for clearing BIOS Password (Supervisor Password and User Password).
174
All manuals and user guides at all-guides.com
Chapter 5
Advertisement
Table of Contents
