Advertisement
Step 2:
Orient and align the Bracket LH (1), as shown, and slide-in the Mounting screws and washers as shown. The
Mounting Hole on the Top side, accepts Screw M5 x 16 (7) – 1 off and Washer M5 (9) – 1 off, as shown. The
Mounting Hole on the Side, accepts Screw M6 x 16 (6) – 1 off and Washer M6 (8) – 1 off, as shown. Tighten it to
torque, as specified in the BOM table. Mount the Mounting Pin (3) – 2 off, to the Bracket (this can be done Off-line
too). The Pin has threaded shank which can be screwed on to the Bracket.
Copyright By SRC
Design and Specification are subjected to change
Mounting Instructions
Step 1:
The Mounting Holes marked in Red colour, will
be exposed, when the Windshield is removed,
as shown.
Step 3:
Repeat the Step 2 for mounting the
Bracket RH (4), as shown.
Page 3
Advertisement
