Electrical Connection - Miele PDR 918 HP Operating And Installation Instructions

Installation
38
If the heat pump unit is tilted up to a maximum of 30° during
transportation, it must be left to stand for at least one hour after it has
been installed before the heat pump dryer can be operated.
If the heat pump unit was tilted by an angle exceeding 30° or if it was
subjected to strong vibrations, the machine must be left to stand for
24 hours before commissioning.
After transportation and installation, downtime of at least one hour
is required before connecting the tumble dryer to the electricity
supply.
Insufficient downtime before commissioning can damage the heat
pump.

Electrical connection

The electrical connection must be established by a qualified
electrician.

The electrical connection may only be made to an electrical system
provided in accordance with all appropriate local and national
legislation, regulations and guidelines. Please also observe the
regulations set out by your insurance provider and energy supplier,
accident prevention regulations, as well as recognised codes of
practice.

Reliable and safe operation of this tumble dryer is only ensured if it
has been connected to the mains electricity supply.
The required supply voltage, power rating and fuse rating can be
found on the data plate on the tumble dryer. Ensure that the supply
voltage matches the voltage quoted on the data plate before
establishing the electrical connection to the tumble dryer.
Connection to a supply voltage other than the one quoted on the
data plate can damage the tumble dryer if the voltage is too high.

This device is intended for connection to a power supply system
where the impedance Zmax of 0.4482 Ohms at the point of
distributor supply connection is not exceeded. If in doubt, please ask
your electrical distributor for the actual Zmax value. The user has to
ensure that this device is connected only to a power supply system
which fulfills the requirement above.

If more than one voltage is specified on the data plate, the tumble
dryer can be converted for connection to the relevant input voltage.
This conversion must be performed by the Miele Professional Service
Department or by an authorised technician. During the conversion,
the wiring instructions given on the wiring diagram must be followed.
The tumble dryer can either be hard-wired or connected using a plug
and socket connection. For a hard-wired connection, an all-pole
isolation device must be available at the installation site.