Pptp - D-Link EBR-2310 User Manual

Section 3 - Configuration
Choose PPTP (Point-to-Point-Tunneling Protocol ) if your ISP uses a PPTP connection. Your ISP will provide you with
a username and password. This option is typically used for DSL services.

PPTP:

Select Dynamic (most common) or Static. Select
Static if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses.
IP Address:
Enter the IP address (Static PPTP only).
Subnet Mask:
Enter the Primary and Secondary DNS Server
Addresses (Static PPTP only).
Gateway:
Enter the Gateway IP Address provided by your ISP.
DNS:
The DNS server information will be supplied by your
ISP (Internet Service Provider.)
Server IP:
Enter the Server IP provided by your ISP (optional).
PPTP Account:
Enter your PPTP account name.
PPTP Password:
Enter your PPTP password and then retype the
password in the next box.
Maximum Idle Enter a maximum idle time during which the Internet
Time: connection is maintained during inactivity. To disable this feature, enable Auto-reconnect.
MTU: Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the
default MTU.
Connect Mode:
Select either Always-on, Manual, or Connect-on demand.
D-Link EBR-2310 User Manual
Internet Setup
PPTP
20