Table of Contents
Advertisement
FIRST THING TO KNOW ABOUT SOFTWARE INSTALLATION
The ISDN TA PC Card is designed to support a wide bandwidth of
interfaces/drivers for a total solution in different environments. The software
setup procedures accordingly vary from interfaces/drivers to interfaces/drivers.
To help you set up the software efficiently, the software installation is
organized by interfaces under Windows 95/98/2000 and Windows NT
respectively.
The following figures are illustrated as guideline-like flow charts. If something
goes wrong, track down the flow to check if there is any procedure missing
while setting up; and move to the corresponding section for details.
The blocked area indicate that after when setup.exe has been executed
(see section titled "Installing Device Driver"), the Phone Dialer
VCOMM Port driver, CAPI 2.0 and the ISDN Low Level Driver were
also installed. You may then use Phone Dialer or the functions with
VCOMM directly.
For CAPI mode, however, it is required to install RVS.COM Center
beforehand to enable the functions with CAPI.
For NDIS mode, unless the NDIS Port Driver has been installed, the
ISDN Low level Driver won't be able to work.
W indows 95/98/2000
Hyper Ter minal
VCOMM
* PPP
VCOMM Por t
*
V.110
*
V.120
Driver
ISDN Low
Level Driver
DUN
CAPI
RVS-COM
Center
* PPP
CAPI 2.0
* V.110
*
V.120
Interface
*
X.75
*
Modem
* Eurofile Transfer
* G3 FAX over ISDN
- 6 -
NDIS
* PPP
NDIS Por t
Driver
Advertisement
Table of Contents
