Appendix; Load Default Setting - TP-Link TL-PS210U Network Setup Manual

Appendix:

Load Default Setting

1. Disconnect the external power adapter.
2. Hold down the reset button.
3. Reconnect the external power adapter. Wait about 5~6 seconds.
4. Release the reset button.
5. The MFP server will restart.
WARNING: This will erase all settings of MFP server to default and should be performed with
caution!
After performing a factory default, the default settings will be:
DHCP client: off
IP address: 192.168.0.10
Subnet Mask: 255.255.255.0
Or, you can load the default setting from the WEB management as following:
Reboot the MFP server:
1. Verify the power of MFP server is turned on.
2. Press the reset button once, and then release it.
Or, you can click the Restart button from the WEB management as following:
WARNING: This will restart the MFP server and stop all on-going and pending job jobs!
26