Table of Contents
Advertisement
Top Side Frame Bracket Installation
Before the installation of the Top Side Frame Brackets, locate and remove the hardware used to secure the lower part
of the ROPS to the mower, refer to Figure A. It is recommended to work and install on one side first before moving
onto the other side.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
Remove Hardware
for installation of Top
Mower's
Right Frame Bracket
Rear Frame
Place and position the Top Frame Bracket / Right (Item #1) in between the mower's rear frame and align the bolt
holes of the Top Frame Bracket / Right to the ROPS bolt holes. Refer to the Figures below.
Secure the Top Frame Bracket / Right to the mower relatively loose by using (2) 1/2"-13 x 3-1/2" GR5 HHCS (Item
#2), (2) 1/2" Flat Washers (Item #3) and (2) 1/2"-13 Flange Nuts (Item #4). Refer to Figure A.
Repeat the procedure for the opposite side. Keep the hardware relatively loose until after the installation on pg 11.
Figure B
Figure C
Left Side View
7
Advertisement
Table of Contents
