Table of Contents
Advertisement
Top Assembly To Upper Frame Assembly Installation
Align the Top Assembly Pivot Holes to the Upper Frame Assembly. See Figure A below. Before fastening, pull Rubber
Dust Guard outward to seal against Upper Frame Assembly (towards the mower's operator seat). Fasten the Top
Assembly to the Upper Frame Assembly using (2) 5/16"-18 x 2-1/2" HHCS P#(K0125) and (2) 5/16"-18 Ny-Flange
Locknuts P#(K2516). Leave the Ny-Flange Locknuts slightly loose to allow the Top Assembly to open and close
easily.
Figure A
Inlet Installation
Position the Top Assembly on its side with the Inlet Hole facing
up. See Figure B. 1: Insert the Inlet from inside the Top
Assembly, up through the Inlet Hole, until the Inlet Retaining Lip
meets the Inlet Hole. 2: Position the Inlet as shown in Figure B,
then pull the Inlet until a portion of the Inlet Retaining Lip
protrudes from the Inlet hole. 3: Next, lift the Inlet as shown in
Figure B until all of the Inlet Retaining Lip protrudes from the
Inlet Hole. Once installed, the Inlet should pivot freely about the
Inlet Hole.
Figure B
Inlet
Inlet Flange
20
Pull Rubber Dust Guard
Outward To Seal Against
Upper Frame Back Edge
Pivot Holes
Inlet
Hole
Inlet Retaining Lip
Top Assembly
5/16" x
2-1/2" HHCS
5/16" Ny-Flange
Locknut
Upper Frame
Assembly
Advertisement
Table of Contents
