Advertisement
VERIFY RA320 FUNCTIONALITY
First, check if the status LED is solid green. During the first boot, it is highly likely that the
AP is automatically updating its firmware, indicated by an amber blinking status LED. The
status LED should turn solid green after the upgrade process has finished (normally within
a few minutes). See the LED indicator table below for more details.
Verify access point connectivity—use any 802.11 client device to connect to the RA320 AP
and verify network connectivity using the client device web browser by going to a well-
known web page.
Check network coverage and confirm good signal strength in the desired coverage area.
States
State 1: Power on
State 2: R2OS starting
State 3: R2OS initializing
State 4: Radio up and ready
State 5: SCM connecting
State 6: CWCL connecting
State 7: AP up and running
State 8: Image upgrade
State 9: AP radio down
9
AP Status LED Display
Solid green
Amber solid for 2 seconds
Amber blinking
Not affected
Green blinking
Green fast blinking
Green solid
Amber blinking
Not affected
©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com
Table 1 RA320 LED booting states
Advertisement
