Advertisement
LEDs
Stop LED Blinking
This is to stop the "blinking" triggered in the previous section and set the LEDs back to
normal.
Configurations
All configurable parameters via DM GUI are shown by clicking the "+" mark to the right of
Configuration.
Input designated values in "New Config" while "Current Config" shows the setting in the AP.
After the input is completed, click "Apply and Reboot AP." Then click "OK" in the
confirmation pop-up. A new configuration will be valid once the reboot is completed.
You can leave the parameters empty in case you want to keep the current values.
Figure 8: AP configuration
18
©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com
Advertisement
