Advertisement
LAN Network
These are the AP LAN-related configuration parameters for the target network:
Protocol
IP address allocation for that AP (DHCP or Static)
IP Address (Valid for "Static" only) AP IP address
Netmask
(Valid for "Static" only) netmask of the network
Gateway
(Valid for "Static" only) Gateway address of the network
DNS Server (Valid for "Static" only) DNS server address of the network
VLAN
VLAN ID for tag on AP management packet
(if unnecessary, set "0")
MTU
Packet length of the network
HTTP Proxy
These are the parameters of proxy in case the network requires it for communication
with NMS:
Server
Address
IP address of HTTP proxy server
Port
Port number of http packets toward the proxy server
Username Username for authentication for the proxy server access if it is required
Password
Password for authentication for the proxy server access if it is required
Cellular (not applicable for RA641)
USIM Parameters for LTE Module in RA620M and LTE Dongle (NCXX-UX302NCR) for RA621
and RA620
PIN
PIN for USIM access if PIN is enabled
(PIN is recommended for disabling the operation. There is a risk of locking
the USIM by using the wrong PIN if the AP retries many times in the case of a
failed authentication.)
APN
APN for USIM
Auth
Authentication mode of network access via USIM (both, chap or pap) (small
letters only)
Username Username for authentication of network access
19
©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com
Advertisement
