Advertisement
Additional Information Needed
The information listed below is used during the preconfiguration process:
•
MAC address and serial number of the target AP (You can find them on the label at the
bottom of the AP.)
•
IP address for the target AP in case configuring AP is executed under a network with a
DHCP server
IP Address of the AP
The IP address of the target AP is used to access DM GUI even at stand-alone.
Link-Local IP Address of RA641
The link-local IP address of the Relay2 AP, 169.254.0.0 network, is calculated from the right
four digits of the AP MAC address. For example, if the MAC address is B4:82:C5:00:6B:E6,
then the link-local IP address of that AP is 169.254.107.230. (i.e., hex: 6B => dec: 107 and hex:
E6 => dec: 230).
IP Address for the PC
The Ethernet port of the AP shall be in the same VLAN for the AP.
In case the PC is connected with the AP directly, the AP assigns the link-local IP address to
itself. Thus, the IP address of the PC shall be the same network.
A normal PC assigns its own IP address in the 169.254 network and in the same manner as
the AP.
Connecting the AP with the PC
DM GUI Step 1:
Connect between the AP LAN port and the PC with a LAN cable. Then power
up by connecting the DC power unit to the power connectors.
Confirm that the Ethernet link is active with the LED at the LAN port or the LED on the AP.
•
In the case that the AP and PC are connected directly for RA641, both nodes utilize the
link-local IP address with the 169.254.0.0 network.
13
©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com
Advertisement
