Advertisement
Reboot AP
By clicking "Reboot AP" and "OK" on the confirmation pop-up window, the AP is rebooted.
Figure 7: Confirmation pop-up
window for reboot action
Factory Reset AP
Factory reset is initiated by clicking "Factory Reset AP" followed by "OK" on the
confirmation window.
Note that the AP configuration, including AP logs, will be cleared by a factory reset.
Start LED Blinking
By clicking "Start LED Blinking" followed by "OK" on the confirmation window, the three LEDs
below will start blinking. This feature can be used to identify deployed APs easily at the
site.
Note that LEDs do not show the AP status when this command is active.
17
©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com
Note: A confirmation pop-up window
will appear for all "command" actions.
Designated action is triggered by
clicking "OK."
Advertisement
