Advertisement
(APPENDIX A) DEVICE MANAGER USER INTERFACE
Introduction
The Relay2 Access Point (AP) starts functioning without preconfiguration under typical
network condition. The AP is able to connect to the Relay2 NMS when the following
prerequisites are met:
•
The DHCP server is reachable, and the AP can get an IP address.
•
The AP is able to reach the DNS server.
•
The AP is able to send https packets to the internet directly.*
•
Uplink packet, MTU = 1500, from the AP is accepted by the network.
•
The L2 packet is accepted by the network without VLAN tagging.
In case any item in the list above is not supported—which is a special environment for
Relay2 AP and requires manual preconfiguration—this document shows the procedure of
such manual configuration through the Relay2 Device Manager UI.
The procedure in this document shows the example of the minimal environment in which
the AP is only connected to a PC.
*No proxy between AP and NMS
Preparation
This section shows the preparation for the manual configuration.
Hardware
The required hardware for the configuration is listed below:
•
Relay2 AP to configure
•
AC adapter or POE+ connection
•
PC (web browser used for the configuration)
•
LAN cable (with RJ45 connectors)
•
Ethernet hub (in case it is necessary to connect the AP and PC via the hub)
12
©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com
Advertisement
