Texas Instruments TI-83 Manual Book page 195

Before Using
Select(
Using Select( to
Select Data
Points from a
Plot
Before using
Select(
1. Create two list names and enter the data.
2. Turn on a stat plot, select
and enter the two list names for
12).
3. Use
ZoomStat
To select data points from a scatter plot or xyLine plot,
follow these steps.
1. Press y [
LIST
menu.
OPS Select(
2. Enter xlistname, press ¢, enter ylistname, and then
press ¤ to designate list names into which you want
the selected data to be stored.
3. Press Í. The graph screen is displayed with
in the bottom-left corner.
Left Bound?
4. Press } or † (if more than one stat plot is selected) to
move the cursor onto the stat plot from which you want
to select data points.
5. Press | and ~ to move the cursor to the stat plot data
point that you want as the left bound.
, follow these steps.
" (scatter plot) or
to plot the data (Chapter 3).
] ~
to select
8 8:Select(
is pasted to the home screen.
Ó (xyLine),
and (Chapter
Xlist: Ylist:
from the
Lists 11-13
LIST