Features & Specifications - Travis Industries Lopi 1750 Republic Owner's Manual

6
Installation Options
 Masonry Fireplace Insert
 Zero-Clearance (Metal) Fireplace Insert
Heating Specifications
Approximate Maximum Heating Capacity (in square feet)*
Maximum Burn Time
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside
temperature. It is also affected by the quality and moisture level of the fuel.
This model was not tested for efficiency however it is assigned a default efficiency of 63% by the EPA
under previous subpart AAA. Efficiency of this wood heater will be affected by the operational burn rate
and the moisture content of the wood used as fuel.
Dimensions
(a) Measure side and top clearances from the top plate. Measure front clearances from the stove face
(b) Fireplace Opening
Emissions
This heater meets the 2015 U.S. EPA's crib wood emission limits for wood heaters sold after May 15,
2015. Tested to Method 28, 5H this heater has been shown to deliver heat at rates ranging from 9,300 to
42,200 BTU/hr and an emission value of 1.9g/h.
© Travis Industries
Stove Installation
380 Lbs. (170 Kg)
a
21-3/8"
24-1/4"
(543mm)
(616mm)
(for qualified installers only)
Features
 2.2 Cubic Foot Firebox Volume
 Single Operating Control
 Accepts Logs Up to 18" Long
 Steel Plate Construction (5/16" & 1/4")
 Heavy Duty Refractory Firebrick
 Optional High-Tech Blower
5-3/16"
(132mm)
18-3/4"
(477mm)
10" (254mm)
100-01435
1,200 to 2,000
Up to 10 Hours
21-5/8" (550mm)
19-3/4"
(502mm)
13-1/8" (334mm)
b
Figure 1
4151218