Table of Contents
Advertisement
6
Installation Options
•
Freestanding
•
Freestanding in an Alcove
•
Freestanding in a Mobile Home (US) or Transportable
Building (CAN)
•
Optional High-Tech Blower
•
Optional GreenStart Igniter
Heating Specifications
Approximate Maximum Heating Capacity (in square feet)*
EPA Tested Cord Wood BTUs per Hour**
Maximum Burn Time
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside
temperature. It is also affected by the quality and moisture level of the fuel.
** EPA tests to determine BTU output are achieved with a single load of wood at each burn rate. At home, you are likely to add
more wood to your stove to maintain your desired comfort level. By the simple process of loading your stove with additional
wood, you could achieve up to a 20% higher heat output than established during EPA testing.
This model was tested for efficiency using method B415.1-10 and was determined to have a weighted average Higher Heating
Value (HHV) Overall Heating Efficiency (OHE) of 80.0%. Overall efficiency of the heater may be lower if the heater is
operated without a heat exchange blower or with the installed heat exchange blower turned off.
Dimensions
(a) Side, rear, and corner clearances are measured from the stove top.
(b) Rubber-Tipped Leveling Bolts (at each corner).
Emissions
This heater meets the 2020 U.S. EPA's crib wood emission limits for wood heaters. Tested to EPA,
ASTM E2780-10, ASTM 2515-11, CSA B415.1-10 this heater has been shown to deliver heat at
rates ranging from 12,594 to 42,722 BTU/hr and an emission value of .73g/h.
© Travis Industries
Stove Installation
51mm
19.75"
502mm
Weight: 450 Lbs. (200 Kg)
(for qualified installers only)
Standard Features
•
Single Operating Control
•
Cast Iron Construction
•
Heavy Duty Refractory Firebrick
•
Removable Ashpan
2"
28.25"
718mm
5.25"
134mm
2/13/2024 -1593
up to 2,000 (185 M
2
)
12,594 to 42,722
Up to 10 Hours
31.5"
801mm
a
b
Figure 1
Rockport NGH
Advertisement
Table of Contents
