Snapper SXDST82 Owner's Manual page 49

OPERATION
STARTING/STOPPING THE BLOWER (
• Ensure that the battery is installed in the blower.
• To start the blower, press the On/Off Button located on the blower. You will hear two audible
beeps signaling the blower is active.
• Squeeze the trigger to start the blower.
• Release the trigger to stop.
ADJUSTING THE AIR VELOCITY (
• Ensure that blower is blower is on. The LED above the On/Off Button will illuminate.
• Squeeze the trigger to start the blower.
• Once the blower is on, pull back the lever clockwise to increase the speed. This will lock the
speed at the desired setting.
• To decrease the speed, push the lever counter clockwise to decrease the speed to the desired
setting.
NOTE: If you decrease the speed all the way, the unit will shut off and step one will need to be
repeated.
OPERATING THE BLOWER
• To keep from scattering debris, blow around the outer edges of a debris pile. Never blow
directly into the center of a pile.
• To reduce sound levels, limit the number of pieces of equipment used at any one time.
• Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen
surfaces when water is available.
• Conserve water by using power blowers instead of hoses for many lawn and garden
applications, including areas such as gutters, screens, patios, grills, porches, and gardens.
• Watch out for children, pets, open windows, or freshly washed cars, and blow debris safely
away.
• After using blowers or other equipment, clean up. Dispose of debris properly.
Trigger
Fig. 4
)
See Figure 4.
)
See Figure 5.
Cruise
Control
Lever
13
On/Off
Button
Fig. 5