Snapper SXDST82 Owner's Manual page 14

ASSEMBLY
ADJusTINg THE CuTTINg sWATH (See Figure 5.)
This trimmer is equipped with a line cut-off blade on the guard. The line cut off blade
continuously trims the line to ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and keep line long enough to advance properly.
This trimmer is currently set at the 14 in. cutting swath. To adjust to a cutting swath of 16 in.:
• Remove the battery pack.
• Loosen the blade screw then rotate the line cut-off blade 180°.
• Tighten the blade screw.
Screw
Cut-off blade
Fig. 5
14 14