Attaching The Fan Blades - HAMPTON BAY SINCLAIR AL958-TB Use And Care Manual

Assembly — Attaching the Fan Blades
Removing the rubber
9
packing mounts
□
The fan motor assembly (E) is shipped with rubber
packing mounts (VV) to prevent movement during
transportation. Remove the five rubber packing
mounts (VV) from the fan motor assembly and discard
prior to attaching the blade arms.
Fastening the blade
11
assemblies to the motor
WARNING:
To reduce the risk of personal injury, do not
bend the blade arms (G) while installing, balancing the blades
(F), or cleaning the fan. Do no insert foreign objects between
rotating fan blades (F).
□
Fasten the blade assemblies to the fan motor
assembly (E) by lining up the slots of the blade arms
(WW) with the tabs on the motor (XX).
□
Tighten the two blade arm screws and lock washers
(II) already installed in the blade arms (G).
□
Repeat this procedure for the remaining blade arms
(G).
10
□
Attach the blades (F) to the blade arms (G) using the
three blade attachment screws and fiber washers
(AA). Start a screw with fiber washer (AA) into the
blade arm (G), but do not tighten.
□
Repeat for the two remaining blade attachment
screws and fiber washers (AA).
□
Tighten each screw securely starting with the center
screw. Make sure the blade (F) is straight.
□
Repeat these steps for the remaining blades.
E
VV
II
12
Attaching the blades to the
blade arms
WW
AA
F
G
E
XX
F
G