Table of Contents
Advertisement
Assemble pump lever 1.
#
1
Place pump lever
with the recess on lower-
#
ing screw
2
on the jack.
Turn pump lever
1
clockwise as far as it will
#
go.
2
Lowering screw
is closed.
3
Adapter
To raise the vehicle at the front: adapter
be secured on the jack.
To raise the vehicle at the rear: remove adapter
3
from the jack.
Important notes on using the jack:
Use only the vehicle-specific jack that has
R
been tested and approved by Mercedes-Benz
to raise the vehicle.
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
Position the jack only at the jack support
R
point.
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the vehi-
R
cle.
Never lie under the vehicle.
R
3
must
Do not start the vehicle and do not release the
R
electric parking brake.
Do not open or close any doors or the rear-
R
end door.
Wheels and tires 371
Using the wheel bolt, loosen the wheel bolts
#
on the wheel you wish to change by about one
full turn. Do not unscrew the screws com-
pletely.
& WARNING Risk of injury from incorrect
positioning of the jack
If you do not position the jack correctly at the
appropriate jacking point of the vehicle, the
jack could tip with the vehicle raised.
Only position the jack at the appropriate
#
jacking point of the vehicle. The base of
the jack must be positioned vertically
under the jacking point of the vehicle.
Advertisement
Table of Contents
