Ide Connectors - Supermicro X7DA3 User Manual

IDE Connectors

There are two IDE Connectors (JIDE1:
Blue, JIDE2: White) on the mother-
board. The blue IDE connector (JIDE1)
is designated as the Primary IDE Drive.
The white IDE connector (JIDE2) is des-
ignated as the Secondary IDE Drive,
reserved for Compact Flash Card use
only. (See the note below.) See the
table on the right for pin defi nitions.
*Note: JIDE2 (the white slot) is re-
served for Compact Flash Card use
only. Do not use it for other devices.
If JIDE2 is populated with a Compact
Flash Card, JIDE1 (the blue slot) will
be available for one device only. For the
Compact Flash Card to work properly,
you will need to connect a power cable
to JWF1 fi rst.
LAN1/2
CD2 CD1
Line-In/
Line-
JPAC
Out
Mic
SIM LP IPMI
PCI-Exp x16
PCI-33MHz
Pin#
1
3
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
37
39
CPU
PSF
J17
Fan 1
J3P
JAR
SAS
Controller
2-33
Chapter 2: Installation
IDE Drive Connectors
Pin Defi nitions
Defi nition Pin # Defi nition
Reset IDE 2 Ground
Host Data 7 4 Host Data 8
Host Data 6 6 Host Data 9
Host Data 5 8 Host Data 10
Host Data 4 10 Host Data 11
Host Data 3 12 Host Data 12
Host Data 2 14 Host Data 13
Host Data 1 16 Host Data 14
Host Data 0 18 Host Data 15
Ground 20 Key
DRQ3 22 Ground
I/O Write 24 Ground
I/O Read 26 Ground
IOCHRDY 28 BALE
DACK3 30 Ground
IRQ14 32 IOCS16
Addr1 34 Ground
Addr0 36 Addr2
Chip Select 0 38 Chip Select 1
Activity 40 Ground
8-pin PWR
JPW3
A. IDE#1
B. IDE#2 (Compact Flash)
B A