Tools - Husqvarna K6500 Ring Workshop Manual

The tools below can be obtained from Husqvarna:
506 38 85-02
Press tool for roller
bearings
Removal and fitting of the
●
engagement and support rollers'
bearings.
Fitting of support rollers'
●
sealing collar.
506 37 53-01
Press tool for the engage-
ment roller bearing sleeves
Removal and fitting of the
●
engagement roller bearing sleeves.
506 37 61-02
Press tool for drive wheel
bearings
● Removal and fitting of drive
wheel bearings and drive shaft.
506 36 36-01
Hex key, 6 mm
(Delivered with the machine.)
● Removal/fitting of the support
roller cover.
502 71 27-02
Workshop wrench, Torx T27
Universal use.
●
Workshop wrench, Allen
Universal use.
●
502 50 19-01 3 mm
502 50 18-01 4 mm
502 50 64-01 5 mm
504 90 00-01 6 mm
504 90 00-06
Workshop kit, mm dimen-
sions
Universal use.
●
Allen: 3, 4, 5 and 6 mm.
Socket: 8 mm

TOOLS

● = Service stage
The special tools below are needed for servicing the K6500 Ring,
but are not sold by Husqvarna:
581 54 15-01
Multimeter
Make: Amprobe 37XR-A.
One of few universal instru-
ments that can also measure
inductance (H, Henry).
● Checking of the electric motor's
functions.
Insulation and continuity
tester
Common makes: Megger, Fluke,
etc.
● Checking of the motor's
windings and cabling.
Tachometer
A number of optical tachometer
makes are available.
Checking of the motor's
●
magnets.
Oetiker special pliers
Recommended tool. Sold by distri-
butors of Oetiker hose clips.
Fitting of Oetiker hose clips.
●
16
35