Uses; Tools; Assembly - Husqvarna SpeedMill K750 Operator's Manual And Spare Parts List

Uses:

Cutting and beveling of waste/sewer and supply
water PVC pipe with the proper beveling accessory. Note
this machine is not for cutting and beveling of any non-plas-
tic material. Follow chart for correct accessory to pipe being
cut and beveled (See pipe application chart included in
document package).
WARNING!
ONLY CUT or BEVEL PVC Plastic Pipe with a machine
equipped with a SpeedMill accessory!
DO NOT cut other materials with this machine!
DO NOT cut or bevel ductile iron pipe with a machine
equipped with a SpeedMill accessory!
DO NOT use machine as a standard power cutter without
proper power cutter blade guard. Refer to page 10 "con-
verting the Speedmill to a regular power cutter"
Tools: 12" (305mm) diameter abrasive blade, with a 1"
(25.4mm) arbor (not included).
WARNING!
Use ONLY High Speed Reinforced Abrasive Blades with a mini-
mum speed rating of 6300 rpm.
DO NOT use carbide tipped, wood cutting, or circular saw blades
with this machine!
First Time Assembly:
Tools Required:
• Screwdriver (for arbor lock)(not included).
• 2" (50.8mm) socket, and socket wrench (not included).
• Combination spanner (supplied with machine).
• Torque wrench.
Loosen and remove the blade shaft
screw & washer from the power cut-
ter. Use the combination spanner
supplied, and a Screwdriver to lock
the blade shaft in position, if required.
Use a Screwdriver to lock the blade
shaft in position. Push the screw-
driver into the slot (see picture) and
rotate the arbor until the screwdriver
stops the rotation.
USES, TOOLS, AND ASSEMBLY
Verify that 1" (25.4mm) adapter (P/N
506 37 96-25) is pushed onto blade
shaft so it contacts the inner flange.
The mounting surfaces of the flange
and bushing arbor must be undam-
aged, clean, and free of debris. Ver-
ify that the flange (P/N 506 02 87-01)
has a diameter of 4.13" (105mm).
Mount a 12" (305mm) diameter, 1"
(25.4mm) arbor High Speed Rein-
forced Abrasive Blade (not included)
on the blade shaft.
Mount the SpeedMill accessory hub.
Align the slot in the SpeedMill acces-
sory hub with the face of the shaft.
Make sure the flange face of the
SpeedMill accessory hub contacts the
face of the blade.
Install the blade shaft bolt into the
hub assembly.
Using combination spanner, supplied
with the machine, tighten blade shaft
bolt by turning it clockwise. Torque to
130-215 in-lbs. (15-25 Nm).
Select the SpeedMill accessory for the type of PVC pipe to
be bevelled using the Pipe Application Chart included on
page 12 of this manual.
Bowl Bevelers 506 11 97-01 for:
Waste/Sewer/Drain 4" to 8" in diameter.
Ring Beveler 506 11 96-01 for:
Waste/Sewer/Drain 10" to 36" in diameter.
Supply/Water 4" to 24" in diameter.
peedMill 7
S